Wheelock AIM-3 Manuál s instrukcemi stáhnout pdf (Strana 11)

AIM-3 Manual P83667 C

Rev. C July 2003 Sheet 11 of 12

TROUBLESHOOTING:

While AIM-3 is connected and powered up, switch

SW1 positions SEL. 1, 2, 3 and PHONE to OFF.

Switch ON as to be cofigured.

Verify

Power to

AIM-3

Verify

RMS

Power to

1. Check +/- power connection

from SAFEPATH Panel to AIM-3.

controller printed circuit board.

2. Check RMS fuse on SAFEPATH

2. Check RMS fuse on AIM-3.

from AIM-3 to RMS.

1. Check +/- power connection

audio +/- for unused port.

2. Verify 10K OHM across

is OFF.

1. Verify configuration switch

2. Check TXD and RXD wiring

between AIM-3 and RMS.

between SAFEPATH Panel

1. Check TXD and RXD wiring

and AIM-3.

Check audio +/- pair wiring.

Configuration

Verify

Serial

Communications

Verify

Audio +/-

Verify

Are any LED'S on any

connected RMS lit?

No

No

Are any LED'S on each

connected RMS lit?

Yes

Are any RMS ports

unused?

Yes

Are amber LED's on

RMS flashing about

No

In stand-by non alarm

state, check +/- audio

and +/- RM audio DC voltage.

Is voltage -12V +/-1V?

Yes

Yes

No

No

Support at 1-800-631-2148

Call Wheelock Technical

once per second?

Yes

1 2 ... 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře